FIX the comment function on the CCNA5.0 Scope and Sequence (Draft) page
At the end of document is request comments - sying "Be the first" but when I tried to ADD this comment "Referencing Table 2 CCNA5 Teaching Routing and Switching.
First thing I noticed was the introduction of Multi-Area OSPF in Chapter 7 of the Scaling Networks Course - I do NOT see where SINGLE-Area OSPF has been introduced?
In Table 3 CCNA5 Teaching by Technology, three chapters are devoted to OSPF,(Chapt 6) Single-Area, (Chapter 7) Troubleshooting Single Area and then (Chapter 8) Mulit-Area OSPF
Two chapters are probably enough, but ONE isn't going to make it!
"
it failed to save and does not allow a reply!
Larry Noyes
shared this idea
Hi Larry,
Thank you for your feedback on the DRAFT CCNA 5.0 Scope & Sequence document.
Please note, this is a draft document that we wanted to be sure we delivered it as soon as possible to instructors. This is for instructors to begin their review and examination. The first two courses of CCNA 5.0 curriculum are much further along and are pretty solid; with the rest less so.
Your observation re: OSPF is correct and will definitely be addressed as we make further progress with CCNA 5.0. Our goal is to make this DRAFT CCNA 5.0 Scope & Sequence document a live document that will correctly reflect our progress.
Please find below the CCNA community page, where our CCNA product manager is moderating the CCNA forum, if you have additional questions:
http://community.netacad.net.
Again, thank you for your feedback!